Your cart is currently empty!
Petit 360i – quick reference guide
| INPUTS | TERMINAL | FROM PETIT # |
| 1 – Wash status | 1 | 0016 / okPoS (Relay Coil) Signal / Left side |
| 2 – Gate loop signal (if used) | 2 | 1034 (Signal / Left side) |
| 3 – Out of service | 3 | not used on Petit |
| 4 – n/a | 4 | |
| 5 – Photo eye – option A | 5 | Entrance photo eye – 1022 (Signal / left side) |
| 5 – Photo eye – option B | 5 | Dryer photo eye – 1023 (Signal / left side) |
| 5 – Photo eye – option C | 5 | Aux exit door eye – 1043 (Signal / left side) |
| OUTPUTS | TERMINAL | TO PETIT # |
| 1 (Bronze) | 1 NO (Normally Open) | 1026 |
| 2 (Silver) | 2 NO (Normally Open) | 1027 |
| 3 (Gold) | 3 NO (Normally Open) | 1028 |
| 4 (Platinum) | 4 NO (Normally Open) | 1029 |
| 5 Bronze buy-up | 5 NO (Normally Open) | 1030 |
| 6 Silver buy-up | 6 NO (Normally Open) | 1031 |
| 7 Gold buy-up | 7 NO (Normally Open) | 1032 |
| 8 Gold buy-up | 8 NO (Normally Open) | 1033 |
Notes:
-Wires are 48″ long except the 0016 wash status wire is 88″ long
-Connect the 24VDC Negative to the Sealevel power input on the left side power block on the rear GND and to the common terminals on the input blocks on the front of the Sealevel.
-Connect the 24VDC Positive to the Sealevel power input on the left side power block on the 9-30 VDC and to the common terminals on the output blocks on the front of the Sealevel.
Petit HMI Settings:
Wash in Use Cycle – Set: “High While Wash in Use”
14.00: How Long to Delay the POS Screen From Changing to Welcome
15.00: How Long to Keep the Signal High After Screen Delay to Simulate WIU and Wash
ENABLED: Use Cycle Signal as “Out of Service” (OFF 1 sec, ON 1 sec, then HOLD ON)
